introduction  |  home  |  contact us    

GCI 'Eagle' double-interlocking clay roofing tile is the FIRST clay roofing tile plant in Asia which utilises the latest Franco-German machinery and technology inclusive of the patented, computerised Hydrocasing tunnel kiln firing system and horizontal tiles firing in individual refractory H-supports.

Its quality clay material coupled with superior glazing technique, provides outstanding insulation and fungus-resisting properties.

GCI Eagle Interlocking Roofing Tiles are available in natural unglazed, glazed and semi-glazed finishings with a wide colour range. Full range of accessory tiles are also available.

Ridge Connecting Standard Tile - Used at the topmost row of roof below Ridge Tiles. Eliminates use of cement mortar. Facilities escape of warm air from below the roof thus improves roof ventilation.

Exhaust Tile - Sits on top of UPVC vent pipe. It connects UPVC vent pipe via a PVC reducer to collar tile and ceramic vent set. Removes flashing need around UPVC air vent pipe. For roof pitch 25º - 45º.

Ridge Connecting Double Tile - Same as Roof Connecting Standard Tile but used only at left roof edge to match Double Tiles.

Ridge End Cap - Used for capping horizontal ridge ends. It overlaps on both Left and Right Verge Tiles to provide a good finish.

Left Verge Tile - Same as Right Verge Tile but used beneath Double Tile on left hand side of roof.

Right Verge Tile - Provide water-tightness to roof edge and lends a solid appearance. Fixed onto wooden fascia board beneath Standard Tiles on right hand side of roof.

Double Tile - Used at left edge of a straight roof to give a similar wave finish at left edge of roof.

Elbow - Used at the bend (135ºC) of a horizontal/main ridge.

Valley Tile - Laid over metal valley gutter to give better finish to roof valley. It allows proper seating and securing of cut tiles with cement mortar. For roof pitch of 20º - 40º.

Eaves Double Tile - Same as Eaves Standard Tile but used only at left roof edge to match Double Tile.

Eaves Standard Tile - Used at the bottom most row of roof i.e. eaves. It prevents vermin and bats from entering roof. Besides, it provides a solid, elegant finish to roof eaves.

Ventilation Tile - Facilities air flow below the roof. It prevents water condensation and humidity on underside of tiles. Installed across a roof slope at 5-feet spacing and at 5th or 6th row from roof ridge. If used together with Ridge Connecting Tiles and/or Ventilation Tape, it greatly improves roof ventilation and brings down roof temperature.

Ridge Tile - Used on horizontal/main ridge formed by 2 roof slopes. Internal width 220mm. Coverage 3 pieces/metre.

3-Way Apex - Used to cover a 3-way Intersection where roof ridge meets with 2 hips.

Hip Tile - Used on inclined ridge i.e. Hip formed by 2 adjoining sloped roofs. Taper shape with internal width 140mm at head and 190mm at tail. 3 pieces/metre.

Standard Tile

Hip End - Starter tile at eaves area of a roof hip. It gives aesthetic finishes and water-tightness.

Eaves Joint - Used where 2 roof eaves join for Hip End/Ridge End to rest on it. Provides better finishing and water-tightness.

Products